Monday, October 5, 2009

Build Your Own Cigar Box Ukulele"Recommendations For Success

By Walker Hayes

Heres a perfect and unique Christmas gift"build a cigar box ukulele from scratch or from a prebuilt kit. If you have seen all the online sites for ukuleles for sale, youve seen the wide range of prices and the host of available models from beginner to professional unit. Think about building your own. Not sure if you have all you need? Consider the following techniques and recommendations and you will see that you can build a beautiful, good sounding, acoustical instrument. Cigar box ukuleles are relatively simple to make and at the same time offer you the ability to build a high quality, well playing acoustical instrument.

No matter which of the basic ukuleles you choose"soprano, concert, tenor or baritone, you can have a successful build, if you start at the right place. The place to start is the box, which is the most unique part of a cigar box instrument. Thats our primary concern here; pay close attention to the following four key elements 1. Use the right box 2. Reinforce the box 3. Use the right hardware and attachment methods 4. Follow the rules

Let us start with #1 Use the right box. Cigar box ukuleles originated as an outgrowth of the tramp art culture where the idea was to build with discarded materials, or at the least to use leftovers that were meant for a completely different initial use. So bear in mind that your sound box, that most basic element of any ukulele building kit, depends in this case on using discarded, although oftentimes extravagant, very well constructed and enchantingly beautiful, packaging material. Cigar boxes come in a very wide range of sizes, shapes, length to width ratios, thicknesses and materials (dont use all-cardboard boxes), not to mention how well, or not, they are constructed. Pick whatever suites your fancy, but bear in mind the following guidelines for optimum size depending on the instrument you are building.

Soprano Ukulele use a box between 7 and 9 long Concert Ukulele use a box between 8 and 10 long Tenor Ukulele use a box between 8 and 10 long Baritone Ukulele use a box between 9 and 11 long

When choosing the length you wont have much control over the width, but remember that anything less than 6 in width will have a tendency to reduce the acoustic effect, and as a rule wider is better. Deep can be better too, up to a limit, with a minimum depth of just over 2. Dont overlook the need for reinforcing your box. Use x blocks glued inside the corners of your box with top-quality Titebond II wood glue or equal. A thin, even coat of glue on two sides of each block is all you need. Place these blocks so they float above the bottom of the box. This bottom of the box is usually solid or laminated wood, and will become the sound board for your instrument, and not allowing the blocks to touch the bottom prevents any interference with soundboard vibration. Use a 3/16 x 3/8 support block glued on its edge inside the soundboard directly below or very near the location of the bridge. This will reduce the slight indentation of the soundboard caused by string tension.

Dont use cheap attachment methods or anything less than high quality screws. Use an awl or a nail set to mark an indention in the box so the screws and other fasteners will be located exactly. Pre-drill any pilot holes for fasteners and use only hand tools to drive screws or tighten nuts. Dont skimp on fasteners and other attachments. Use only the best.

This is important. Dont forget number four on the list, follow the rules. You may have heard that in the cigar box ukulele and banjo world there are no rules. There really are just two. Rule #1 is Do it your way, and rule #2 is Dont forget rule #1. Pay attention to the basic box preparation steps above, use a good box for your purpose, use your creative imagination, and, above all, follow the rules. Good luck and good building.

About the Author:

0 comments:

Post a Comment